retention time raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
Reviewed 2026-05-27. Anything still debated is marked as such rather than presented as settled.
Routine HPLC testing compares a sample result with a calibration curve prepared from known reference standards. Peak area or peak height is plotted against concentration, and the curve is used to estimate unknown amounts. Retention time supports tentative identification when compared with a standard, though mass spectrometry or another confirmatory method may be needed for definitive identification. Pre-run checks verify repeatability, resolution, and peak symmetry before sample analysis. Limits of detection and quantification describe the smallest amounts that can be reliably observed or measured. Sample preparation, filtration, and degassing help prevent column damage and inconsistent results.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample. A pump moves a liquid mobile phase through a column packed with a solid stationary phase. Compounds interact differently with both phases and travel at different rates, leaving the column at distinct retention times. A detector records these arrivals as peaks on a chromatogram. The resulting pattern supports identification and quantification of substances in mixtures. Modern instruments use high pressure to force solvent through small particles, which improves speed and resolution compared with older low-pressure liquid chromatography methods.
Validation establishes that a method is suitable for its intended purpose. Typical parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantification, robustness, and stability of standards and samples. Acceptance criteria are defined in advance, and results are documented in a validation report. Regulatory guidance for pharmaceuticals, foods, and environmental testing differs, so the applicable framework must be identified. Ongoing verification uses control samples and trend charts after validation. Method transfer to another laboratory may require partial revalidation.
Routine quality control includes blanks, duplicates, spiked samples, and certified reference materials. Calibration curves are prepared with standards at several concentrations, and the detector response is checked for linearity. Carryover, column aging, mobile phase evaporation, and temperature drift can shift retention times or peak areas. Maintenance such as replacing seals, filters, and columns helps prevent failures. Records of injections, integration, and deviations support traceability. Audits may request raw data and instrument logs for each batch.
| Property | Value | Notes |
|---|---|---|
| Common abbreviation | HPLC | High-performance liquid chromatography |
| Separation basis | Differential partitioning | Between liquid mobile phase and solid stationary phase |
| Common mode | Reverse phase | Nonpolar column, polar mobile phase |
| Typical detector | UV-Vis absorbance | Widely used for compounds with chromophores |
| Typical column particle size | 2–5 µm | Smaller particles can improve resolution |
Key performance measures include retention time, peak area, peak height, resolution, tailing factor, and plate count. Retention time helps identify a peak under fixed conditions, but confirmation often requires a second method or detector. Peak area and height relate to concentration through calibration curves, which may be linear or nonlinear depending on the detector response. Resolution describes separation between adjacent peaks, while tailing factor and plate count describe peak shape and column efficiency. Performance checks verify these values before and during a run to confirm that the instrument is performing within limits.
High-performance liquid chromatography testing separates components of a liquid sample by forcing a mobile phase through a packed column. The stationary phase inside the column interacts with analytes to different degrees, so each compound exits at a characteristic retention time. A pump delivers solvent at controlled flow and pressure, while an injector introduces a precise sample volume. Detectors such as ultraviolet-visible, fluorescence, refractive index, or mass spectrometric instruments record the separated bands. The resulting chromatogram provides qualitative and quantitative information about the mixture.
== Automation == There have been some efforts in automating the generation of inclusion lists through the solution of external software. In 2010, Wu et al. introduced a semi-automatic method in an effort of identifying low-abundance glyco-peptide. They implemented the automation through iterative experiments and the open-source software GLYPID. With minor modification, this approach can be used in analyzing any other simple or complex samples. In addition to the advantage mentioned before, this semi-automated approach also saves substantial amount of time and efforts for scientists in manually picking ions and re-calibrating instruments.
Ranpak Holdings Corp. manufactures machines and paper products used in protective paper-based packing for shipping goods and merchandise for e-commerce and industry, along with automation solutions. The company is based in Concord, Ohio, and has production facilities and offices in Reno, Nevada; Kansas City, Missouri; the Netherlands; Czech Republic; Shanghai and Singapore. The paper packaging material can be used for multiple applications like wrapping, cushioning, void fill and cold chain purposes, and is sometimes known as dunnage. Ranpak counts customers globally like Amazon, IKEA, and Walmart.
=== West === In the West, one of the first known mentions of freeze-dried tofu was by Paillieux in 1880, "Sometimes during the winter tofu is frozen, then dried to give it a sponge-like texture. In this state, it lasts a long time and can be cooked in various ways." Trimble mentioned the koya-dofu in the United States in 1896. It was mentioned as kori-tofu in 1899. In 1904, a mention appeared in the article "The Use of Frost in Making Japanese Foods," by Loew. In 1906, Senft, a member of the German Military Food Administration, mentioned koya-dofu as a preserved food used by the Japanese military during the Russo-Japanese War.
Short-wave ultraviolet radiation can destroy DNA in living microorganisms. UVC's effectiveness is directly related to intensity and exposure time. UV has also been shown to reduce gaseous contaminants such as carbon monoxide and VOCs. UV lamps radiating at 184 and 254 nm can remove low concentrations of hydrocarbons and carbon monoxide if the air is recycled between the room and the lamp chamber. This arrangement prevents the introduction of ozone into the treated air. Likewise, air may be treated by passing by a single UV source operating at 184 nm and passed over iron pentaoxide to remove the ozone produced by the UV lamp.
Sources: en.wikipedia.org
The condition known today as diabetes (usually referring to diabetes mellitus) is thought to have been described in the Ebers Papyrus (c. 1550 BC). Ayurvedic physicians (5th/6th century BC) first noted the sweet taste of diabetic urine, and called the condition madhumeha ("honey urine"). The term diabetes traces back to Demetrius of Apamea (1st century BC). For a long time, the condition was described and treated in traditional Chinese medicine as xiāo kě (消渴; "wasting-thirst"). Physicians of the medieval Islamic world, including Avicenna, have also written on diabetes. Early accounts often referred to diabetes as a disease of the kidneys. In 1674, Thomas Willis suggested that diabetes may be a disease of the blood. Johann Peter Frank is credited with distinguishing diabetes mellitus and diabetes insipidus in 1794. In regard to diabetes mellitus, Joseph von Mering and Oskar Minkowski are commonly credited with the formal discovery (1889) of a role for the pancreas in causing the condition. In 1893, Édouard Laguesse suggested that the islet cells of the pancreas, described as "little heaps of cells" by Paul Langerhans in 1869, might play a regulatory role in digestion. These cells were named islets of Langerhans after the original discoverer. In the beginning of the 20th century, physicians hypothesized that the islets secrete a substance (named "insulin") that metabolises carbohydrates. The first to isolate the extract used, called insulin, was Nicolae Paulescu.
=== Isomers === The term "dehydroepiandrosterone" is ambiguous chemically because it does not include the specific positions within epiandrosterone at which hydrogen atoms are missing. DHEA itself is 5,6-didehydroepiandrosterone or 5-dehydroepiandrosterone. A number of naturally occurring isomers also exist and may have similar activities. Some isomers of DHEA are 1-dehydroepiandrosterone (1-androsterone) and 4-dehydroepiandrosterone. These isomers are also technically "DHEA," since they are dehydroepiandrosterones in which hydrogens are removed from the epiandrosterone skeleton. Dehydroandrosterone (DHA) is the 3α-epimer of DHEA and is also an endogenous androgen.
Minoxidil, 6-amino-1,2-dihydro-1-hydroxy-2-imino-4-piperidinopyrimidine, is synthesized from barbituric acid, the reaction of which with phosphorus oxychloride gives 2,4,6-trichloropyrimidine. Upon reaction with ammonium, this turns into 2,4-diamino-6-chloropyrimidine. Next, the resulting 2,4-diamino-6-chloropyrimidine undergoes a reaction with 2,4-dichlorophenol in the presence of potassium hydroxide, giving 2,4-diamino-6-(2,4-dichlorophenoxy)-pyrimidine. Oxidation of this product with 3-chloroperbenzoic acid gives 2,4-diamino-6-(2,4-dichlorophenoxy)pyrimidine-3-oxide, the 2,4-dichlorophenoxyl group of which is replaced with a piperidine group at high temperature, giving minoxidil.
nebeprisikiškiakopūstlapiaujančiuosiuose – "in those, of masculine gender, who aren't gathering enough wood sorrel's leaves by themselves anymore." – the plural locative case of past iterative active participle of verb kiškiakopūstlapiauti meaning "to pick wood-sorrels' leaves" (leaves of edible forest plant with sour taste, word by word translation "rabbit cabbage"). The word is attributed to software developer / writer Andrius Stašauskas.
The simplest way to do this is to remove the gene and see what phenotype develops compared to the wild type form. Any differences are possibly the result of the missing gene. Unlike mutagenisis, genetic engineering allows targeted removal without disrupting other genes in the organism. Some genes are only expressed in certain tissues, so reporter genes, like GUS, can be attached to the gene of interest allowing visualization of the location. Other ways to test a gene is to alter it slightly and then return it to the plant and see if it still has the same effect on phenotype. Other strategies include attaching the gene to a strong promoter and see what happens when it is overexpressed, forcing a gene to be expressed in a different location or at different developmental stages.
Sources: en.wikipedia.org
Iron is required for life. The iron–sulfur clusters are pervasive and include nitrogenase, the enzymes responsible for biological nitrogen fixation. Iron-containing proteins participate in transport, storage and use of oxygen. Iron proteins are involved in electron transfer. The ubiquity of Iron in life has led to the Iron–sulfur world hypothesis that iron was a central component of the environment of early life.
== History == RNAP was discovered independently by Sam Weiss, Audrey Stevens, and Jerard Hurwitz in 1960. By this time, one half of the 1959 Nobel Prize in Medicine had been awarded to Severo Ochoa for the discovery of what was believed to be RNAP, but instead turned out to be polynucleotide phosphorylase.
Lithium both directly and indirectly inhibits GSK3β (glycogen synthase kinase 3β) which results in the activation of mTOR. This leads to an increase in neuroprotective mechanisms by facilitating the Akt signaling pathway. GSK-3β is a downstream target of monoamine systems. As such, it is directly implicated in cognition and mood regulation. During mania, GSK-3β is activated via dopamine overactivity. GSK-3β inhibits the transcription factors β-catenin and cyclic AMP (cAMP) response element binding protein (CREB), by phosphorylation. This results in a decrease in the transcription of important genes encoding for neurotrophins. Inhibition of GSK3β reverses this change. In addition, several authors proposed that pAp-phosphatase could be one of the therapeutic targets of lithium. This hypothesis was supported by the low Ki of lithium for human pAp-phosphatase compatible within the range of therapeutic concentrations of lithium in the plasma of people (0.8–1 mM). The Ki of human pAp-phosphatase is ten times lower than that of GSK3β (glycogen synthase kinase 3β). Inhibition of pAp-phosphatase by lithium leads to increased levels of pAp (3′–5′ phosphoadenosine phosphate), which was shown to inhibit PARP-1. Another mechanism proposed in 2007 is that lithium may interact with the nitric oxide (NO) signalling pathway in the central nervous system, which plays a crucial role in neural plasticity. The NO system could be involved in the antidepressant effect of lithium in the Porsolt forced swimming test in mice.
Adrenocorticotropic hormone is used as a medication and as diagnostic agent in the ACTH stimulation test. The form that is purified from pig pituitary glands is known as corticotropin is a medication and naturally occurring polypeptide tropic hormone produced and secreted by the anterior pituitary gland. The form that is made synthetically is tetracosactide, also known as synacthen, tetracosactrin and cosyntropin. It consists of the first 24 (of a total of 39) amino acids of ACTH and retains full function of the parent peptide. Tetracosactide stimulates the release of corticosteroids such as cortisol from the adrenal glands, and is used for the ACTH stimulation test to assess adrenal gland function.
Sources: en.wikipedia.org
HPLC testing measures the presence and amount of one or more compounds in a liquid sample. It separates mixture components and records detector responses as peaks, which are compared with reference standards. Results are usually reported as concentrations or relative percentages.
Retention time is the interval between sample injection and the detector response for a given compound. It depends on the compound's interactions with the stationary and mobile phases under set conditions. Matching a retention time to a standard supports tentative identification but is not always unique.
HPLC alone can separate unknown compounds and provide retention times, but it often cannot identify them with certainty. Coupling HPLC to mass spectrometry gives mass information that improves identification. Confirmation usually requires comparison with reference standards or complementary techniques.
System suitability is a set of checks performed before and during a run to confirm that the instrument, column, and method work as expected. Common checks include resolution, tailing factor, theoretical plates, and relative standard deviation of replicate injections. Failure triggers troubleshooting or method adjustment.