The short version of Method validation fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2026-05-10 and is reviewed periodically as new material appears.
Quality control laboratories use HPLC to check identity, purity, concentration, and stability of raw materials and finished products. A validated method specifies the column, mobile phase, flow rate, detection wavelength, injection volume, and run time. Samples are prepared and compared against reference standards of known concentration. The resulting chromatogram provides quantitative data, such as assay values and impurity levels. This approach is common in pharmaceutical, food, environmental, and industrial testing where consistent measurements are required.
Method validation demonstrates that an analytical procedure is suitable for its intended purpose. Typical validation characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulatory guidance from bodies such as the International Council for Harmonisation and the United States Pharmacopeia outlines expectations, though specific criteria depend on the product and method. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, column efficiency, and injection repeatability. Failure of these checks can invalidate a batch of measurements.
Most routine HPLC testing uses reversed-phase columns, where the stationary phase is nonpolar and the mobile phase is a polar mixture such as water with an organic solvent. Analytes partition between the two phases according to polarity, size, and charge. Gradients that change solvent composition over time can separate compounds with broad retention ranges. Isocratic conditions keep solvent composition constant and suit simpler mixtures. The choice of column chemistry, pH, and temperature affects selectivity and peak shape.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. UV detection is widely used because many organic compounds absorb light, but it requires a chromophore. Mass spectrometry provides mass-based identification and high sensitivity for trace analytes. Each detector has trade-offs in selectivity, cost, and compatibility with mobile phases. Quantification typically uses calibration curves prepared from reference standards. Results are reported as concentration, purity, or presence above a limit.
HPLC testing separates dissolved compounds by passing a liquid sample through a column packed with stationary phase. A pump delivers mobile phase at controlled flow, and the sample components interact differently with stationary and mobile phases. Compounds that spend more time in mobile phase elute earlier; those retained by stationary phase elute later. Detectors record elution as peaks, and peak area or height relates to amount. This mechanism underpins quantitative analysis of mixtures.
| Parameter | Typical acceptance criterion | Notes |
|---|---|---|
| Resolution | ≥ 1.5 | Baseline separation of adjacent peaks |
| Tailing factor | ≤ 2.0 | Peak symmetry measure |
| Theoretical plates | > 2000 | Column efficiency indicator |
| Injection repeatability | ≤ 2% RSD | Relative standard deviation for replicate injections |
| Linearity | r² ≥ 0.995 | Calibration curve over the working range |
Method validation demonstrates that an HPLC procedure is suitable for its intended purpose. Common validation parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantification, and robustness. Accuracy reflects agreement with a reference value, while precision describes repeatability under defined conditions. Specificity shows whether the method can measure the analyte in the presence of impurities or matrix components. Validation documents are reviewed before a method is used for routine testing or regulatory submissions.
System suitability testing is performed before and during analytical runs to confirm that the instrument and method are working as expected. Typical checks include retention time, peak area precision, resolution between critical pairs, tailing factor, and theoretical plate count. Acceptance criteria are set in the method or pharmacopeial monograph. If a suitability check fails, the run may be rejected and the instrument or sample preparation may need investigation. This practice helps prevent release of data from a system that has drifted out of control.
Quality control samples are inserted at intervals to monitor accuracy and precision throughout a batch. Blank samples detect contamination, while spiked samples assess recovery from the sample matrix. Calibration standards establish the relationship between detector response and concentration, and control samples are prepared independently from them whenever possible. Laboratories also participate in proficiency testing and maintain audit trails, instrument logs, and reagent records. Ongoing review of control charts can reveal trends before they cause out-of-specification results.
In T cells, IRAP regulates the trafficking of TCD3ζ chains, that are recruited to IRAP intracellular vesicles, as well as endosomal signalling by the TCR complex. IRAP depletion increases the TCR levels at the cell surface which, however, display defective signalling. Other studies demonstrated that IRAP regulates Toll-like receptor 9 (TLR9) activation by delaying maturation of TLR9-containing endosomes to lysosomes and limiting, as a consequence, TLR9 cleavage and activation. Finally, IRAP has an important role in the secretion of the proinflammatory cytokines TNFa and IL-6 by mast cells. In the absence of IRAP, the trafficking of vesicles containing TNFα and IL-6 from the Golgi to the plasma membrane is impaired.
One of these first-generation IUDs was the Dalkon Shield, whose poor design caused bacterial infection and led to thousands of lawsuits. Although it was removed from the market, the Dalkon Shield had a lasting, negative impact on IUD use and reputation in the United States. The invention of the copper IUD in the 1960s introduced the capital T-shaped design used by most modern IUDs. U.S. physician Howard Tatum determined this shape would work better with the space of the uterine cavity. He predicted this would reduce rates of IUD expulsion. Further, Tatum and Chilean physician Jaime Zipper discovered that copper could be an effective spermicide and developed the first copper IUD. Improvements by Tatum led to the creation of the TCu380A (ParaGard), which is the preferred copper IUD since 1997. The hormonal IUD was also invented in the 1960s and 1970s with the goal of mitigating the increased menstrual bleeding associated with copper and inert IUDs. The first model, Progestasert, lasted for one year of use and was quickly discontinued. The Mirena hormonal IUD was released in 1976.
=== Digital circuitry === One-hot encoding is often used for indicating the state of a state machine. When using binary, a decoder is needed to determine the state. A one-hot state machine, however, does not need a decoder as the state machine is in the nth state if, and only if, the nth bit is high. A ring counter with 15 sequentially ordered states is an example of a state machine. A 'one-hot' implementation would have 15 flip-flops chained in series with the Q output of each flip-flop connected to the D input of the next and the D input of the first flip-flop connected to the Q output of the 15th flip-flop. The first flip-flop in the chain represents the first state, the second represents the second state, and so on to the 15th flip-flop, which represents the last state. Upon reset of the state machine all of the flip-flops are reset to '0' except the first in the chain, which is set to '1'. The next clock edge arriving at the flip-flops advances the one 'hot' bit to the second flip-flop. The 'hot' bit advances in this way until the 15th state, after which the state machine returns to the first state. An address decoder converts from binary to one-hot representation. A priority encoder converts from one-hot representation to binary.
== Awards and honours == 1964: Blue Key Award: University of Southern California, Los Angeles, USA. 1965–1970: Medical Research Scholar Award (Canada). 1977: USSR Academy of Sciences invitation to lecture in Academies/Universities in Moscow, Pouschino, Novosibirsk, Tashkent, and Leningrad as a visiting professor. 1977: Nuffield Foundation Award, U.K. 1977: Member of the High Table, King's College, University of Cambridge, U.K. 1981–1982: Chairman: Biological Chemistry Division, Chemical Institute of Canada. 1982: Invited to speak at the 56th Nobel Symposium on Inorganic Biochemistry under the auspices of the Nobel Foundation, Sweden. 1984 : Visiting Professor : Université de Paris Nord, Paris, France. 1986: Elected Fellow of the Chemical Institute of Canada (FCIC). 1988: Chinese Academy of Sciences invitation to lecture in Academies/Universities in Beijing, Guiyang and Hangzhou as Visiting Professor. 1996: Commencement Speaker, Akdeniz University, Antalya (Turkey). 1998: Honorary Professor, Ambedkar Center for Biomedical Research, University of Delhi, New Delhi, India. 2000: Visiting Professor (European Union) University of Ioannina, Greece. 2002: Visiting Professor, National University of Singapore, Singapore. 2003: Research Institute (SickKids) Citizenship Award of the Year. 2004: Received R. C. Mehrotra Award for Science from the Vice President of India at the International Conference on Chemistry Biology Interface: Synergistic New Frontiers, New Delhi, India.
Sources: en.wikipedia.org
== Life == Micah True was born Michael Randall Hickman in Oakland, California, the son of a Korean War Marine Corps Gunnery Sergeant and the second of four children. He grew up traveling the country as his family relocated to various nationally located Marine Corps bases. His family was conservative Roman Catholic, but True aligned himself with the counter-culture movement of the 1960s and 70s. True attended Humboldt State University, where he studied Eastern religions and Native American history. To earn money he began prizefighting in informal boxing bouts, using the name "Gypsy Cowboy," and perhaps taking the occasional dive for an easy payday. Between 1974 and 1982, Hickman was a professional middleweight boxer, fighting under the name Mike "True" Hickman. His career record was 9 wins (KO 2), 11 losses (KO 9), and 0 draws. At some point True spent 10 months living in a cave in Hawaii where he fell in love with a rich girl. It was when she left him, he said, that he took up long-distance running. He also changed his name from Michael Hickman to Micah True. (The name Micah comes from the Bible, while True came from the name of a beloved pet: True Dog.) By 1982, True had moved to Boulder, Colorado, where he began working as a self-employed furniture mover. By then he had become a "trailrunning bum" (like a "surfing bum or a climbing bum"). For almost 20 years, he spent winters running in Mexico, Guatemala, and Central America, averaging 170 miles (270 km) per week. He would return to Boulder during the summers to earn enough money to live on the rest of the year.
==== 2000s ==== In April 2003, Starbucks acquired Seattle's Best Coffee and Torrefazione Italia from AFC Enterprises for US$72 million. The deal only gained 150 stores for Starbucks, but according to the Seattle Post-Intelligencer, the wholesale business was more significant. By June 2003, Starbucks Japan had 466 stores and would add another 70 to 75 in the 2003 financial year. Its president, Yuji Tsunoda said it would install ovens in all stores to improve its food offerings. From 2005 to 2007, Howard Behar served as the president of Starbucks North America. In September 2006, rival Diedrich Coffee announced that it would sell most of its company-owned retail stores to Starbucks, including most locations of Oregon-based Coffee People, escalating regional coffee wars. Starbucks converted the Diedrich Coffee and Coffee People locations to Starbucks. The Coffee People locations at Portland International Airport were excluded from the sale. In early 2008, Starbucks started a community website, My Starbucks Idea, designed to collect suggestions and feedback from customers. Other users could comment and vote on suggestions. Journalist Jack Schofield noted that "My Starbucks seems to be all sweetness and light at the moment, which I don't think is possible without quite a lot of censorship." In March 2008, Starbucks acquired Coffee Equipment Company, which was the manufacturer of the Clover Brewing System. It began testing the "fresh-pressed" coffee system at several Starbucks locations in Seattle, California, New York, and Boston.
== Personal life == Little is married to former investment banker, Jane Hansen, his second wife. In 2002, they paid a then record price for a Melbourne home when they bought the Toorak mansion Coonac for nearly A$15 million. Little's first wife, Shirley, died of cancer in 1992. Little has three children. Little and Hansen's philanthropic interests are directed towards education, theatre, and addiction rehabilitation. In 2015 Little and Hansen established The Hansen Trust via an A$10 million gift from the Hansen Little Foundation to the University of Melbourne to further the teaching of history studies. In 2018 the Hansen Little Foundation gifted a further A$30 million to the university.
Sources: en.wikipedia.org
Method validation is the documented process of confirming that an HPLC procedure is suitable for its intended use. It evaluates accuracy, precision, specificity, linearity, range, detection limits, and robustness. Validation criteria depend on the regulatory context and the sample type.
System suitability tests are short checks performed before or during an HPLC run to verify instrument and method performance. They often include resolution, tailing factor, theoretical plates, and injection precision. Results must meet predefined limits for sample data to be accepted.
HPLC retention time alone cannot definitively identify an unknown substance. A match with a reference standard under identical conditions provides supporting evidence. Confirmation typically requires mass spectrometry, nuclear magnetic resonance, or another orthogonal technique.
It separates components in a liquid sample and measures their amounts using a detector. Results can indicate concentration, purity, or identity based on retention time and detector response. The technique works for mixtures that can be dissolved and filtered.