The short version of HPLC fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-04-27. Anything still debated is marked as such rather than presented as settled.
Quality control samples are inserted at intervals to monitor accuracy and precision throughout a batch. Blank samples detect contamination, while spiked samples assess recovery from the sample matrix. Calibration standards establish the relationship between detector response and concentration, and control samples are prepared independently from them whenever possible. Laboratories also participate in proficiency testing and maintain audit trails, instrument logs, and reagent records. Ongoing review of control charts can reveal trends before they cause out-of-specification results.
Method validation demonstrates that an HPLC procedure is suitable for its intended purpose. Common validation parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantification, and robustness. Accuracy reflects agreement with a reference value, while precision describes repeatability under defined conditions. Specificity shows whether the method can measure the analyte in the presence of impurities or matrix components. Validation documents are reviewed before a method is used for routine testing or regulatory submissions.
System suitability testing is performed before and during analytical runs to confirm that the instrument and method are working as expected. Typical checks include retention time, peak area precision, resolution between critical pairs, tailing factor, and theoretical plate count. Acceptance criteria are set in the method or pharmacopeial monograph. If a suitability check fails, the run may be rejected and the instrument or sample preparation may need investigation. This practice helps prevent release of data from a system that has drifted out of control.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. UV detection is widely used because many organic compounds absorb light, but it requires a chromophore. Mass spectrometry provides mass-based identification and high sensitivity for trace analytes. Each detector has trade-offs in selectivity, cost, and compatibility with mobile phases. Quantification typically uses calibration curves prepared from reference standards. Results are reported as concentration, purity, or presence above a limit.
HPLC testing separates dissolved compounds by passing a liquid sample through a column packed with stationary phase. A pump delivers mobile phase at controlled flow, and the sample components interact differently with stationary and mobile phases. Compounds that spend more time in mobile phase elute earlier; those retained by stationary phase elute later. Detectors record elution as peaks, and peak area or height relates to amount. This mechanism underpins quantitative analysis of mixtures.
| Property | Value | Notes |
|---|---|---|
| Validation parameter | Accuracy | Closeness to a reference value. |
| Validation parameter | Precision | Repeatability or intermediate precision. |
| Validation parameter | Linearity | Proportional response across a range. |
| System suitability check | Resolution | Separation between adjacent peaks. |
| Quality control tool | Control chart | Tracks results over time for trends. |
Method validation demonstrates that an analytical procedure is suitable for its intended purpose. Typical validation characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulatory guidance from bodies such as the International Council for Harmonisation and the United States Pharmacopeia outlines expectations, though specific criteria depend on the product and method. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, column efficiency, and injection repeatability. Failure of these checks can invalidate a batch of measurements.
Practical HPLC testing depends on careful sample preparation and instrument maintenance. Samples may require filtration, dilution, pH adjustment, or extraction to avoid column damage and matrix interference. Mobile phases are degassed and filtered, and columns are equilibrated before injection. Common problems include peak tailing, baseline drift, ghost peaks, carryover, and co-elution of analytes. Documentation of instrument logs, calibration records, and electronic audit trails supports data integrity and traceability. Ongoing training and routine maintenance help reduce variability between analysts and laboratories.
Quality control laboratories use HPLC to check identity, purity, concentration, and stability of raw materials and finished products. A validated method specifies the column, mobile phase, flow rate, detection wavelength, injection volume, and run time. Samples are prepared and compared against reference standards of known concentration. The resulting chromatogram provides quantitative data, such as assay values and impurity levels. This approach is common in pharmaceutical, food, environmental, and industrial testing where consistent measurements are required.
On 22 December 1988, the Brazzaville Protocol was enshrined in the Tripartite Accord, which required the SADF to withdraw from Angola and reduce its troop levels in South West Africa to a token force of 1,500 within twelve weeks. Simultaneously, all Cuban brigades would be withdrawn from the border to an area north of the 15th parallel. At least 3,000 Cuban military personnel would depart Angola by April 1989, with another 25,000 leaving within the next six months. The remaining troops would depart at a date not later than 1 July 1991. An additional condition was that South Africa would cease all support for UNITA, and Angola likewise for PLAN and MK. On 20 December 1988, United Nations Security Council Resolution 626 was passed, creating the United Nations Angola Verification Mission (UNAVEM) to verify the redeployment northwards and subsequent withdrawal of the Cuban forces from Angola. UNAVEM included observers from Western as well as non-aligned and communist nations. In February 1989 the United Nations Transition Assistance Group (UNTAG) was formed to monitor the South West African peace process.
nitrogenous base Sometimes used interchangeably with nucleobase or simply base. Any organic compound containing a nitrogen atom that has the chemical properties of a base. Five particular nitrogenous bases – adenine (A), guanine (G), cytosine (C), thymine (T), and uracil (U) – are especially relevant to biology because they are components of nucleotides, which are the primary monomers that make up nucleic acids.
==== Quantification ==== Polyphenolic content in vitro can be quantified by volumetric titration. An oxidizing agent, permanganate, is used to oxidize known concentrations of a standard tannin solution, producing a standard curve. The tannin content of the unknown is then expressed as equivalents of the appropriate hydrolyzable or condensed tannin. Some methods for quantification of total polyphenol content in vitro are based on colorimetric measurements. Some tests are relatively specific to polyphenols (for instance the Porter's assay). Total phenols (or antioxidant effect) can be measured using the Folin–Ciocalteu reaction. Results are typically expressed as gallic acid equivalents. Polyphenols are seldom evaluated by antibody technologies. Other tests measure the antioxidant capacity of a fraction. Some make use of the ABTS radical cation which is reactive towards most antioxidants including phenolics, thiols and vitamin C. During this reaction, the blue ABTS radical cation is converted back to its colorless neutral form. The reaction may be monitored spectrophotometrically. This assay is often referred to as the Trolox equivalent antioxidant capacity (TEAC) assay. The reactivity of the various antioxidants tested are compared to that of Trolox, which is a vitamin E analog. Other antioxidant capacity assays which use Trolox as a standard include the diphenylpicrylhydrazyl (DPPH), oxygen radical absorbance capacity (ORAC), ferric reducing ability of plasma (FRAP) assays or inhibition of copper-catalyzed in vitro human low-density lipoprotein oxidation.
According to current estimations, the maximum length of a replicated chain that can be correctly reproduced and maintained in enzyme-free systems is about 100 bases, which is assumed to be insufficient to encode replication machinery. This observation was the motivation for the formulation of the hypercycle theory.
toluene, ethyl acetate, acetone, ethanol, acetonitrile, chloroform, dichloromethane, etc.) can then be used to determine the acid-base characteristics of the solid using either the Gutmann, or Good-van Oss theory. Other parameters accessible by IGC include: heats of sorption [1], adsorption isotherms, energetic heterogeneity profiles, diffusion coefficients, glass transition temperatures [1], Hildebrand and Hansen solubility parameters, and crosslink densities.
Sources: en.wikipedia.org
=== Morocco === The Party of Progress and Socialism released a statement condemning the capture of Maduro, describing it as "American imperialist aggression" and reiterating the party's "full and complete solidarity with the brotherly Venezuelan people".
=== Parthenogenesis === When female American cockroaches are housed in groups, this close association promotes facultative parthenogenic reproduction. The oothecae are produced asexually, without fertilization. The process by which the eggs are produced is automixis; during automixis, meiosis occurs, but instead of giving rise to haploid gametes as ordinarily happens, diploid gametes are produced (probably by terminal fusion of meiotic products) that can then develop into female cockroaches. Eggs produced by parthenogenesis have lower viability than eggs produced by sexual reproduction.
Hypomethylation due to impaired methylation up regulates atherosclerotic susceptible genes whilst down regulating atherosclerosis protective genes. This abnormality is present during the atherosclerotic pathology, increasing transcriptional activity of platelet derived growth factor (PDGF) and promoting smooth muscle cell proliferation.
== The Strep-tag principle == Just like other short-affinity tags (His-tag, FLAG-tag), the Strep-tag can be easily fused to recombinant proteins during subcloning of its cDNA or gene. For its expression, various vectors for various host organisms (E. coli, yeast, insect, and mammalian cells) are available. A particular benefit of the Strep-tag is its rather small size and the fact that it is biochemically almost inert. Therefore, protein folding or secretion is not influenced and usually it does not interfere with protein function. Strep-tag is especially suited for analysis of functional proteins, because the purification procedure can be kept under physiological conditions. This not only allows the isolation of sensitive proteins in a native state, but it is also possible to purify intact protein complexes, even if just one subunit carries the tag. In the first step of the Strep-tag purification cycle, the cell lysate containing Strep-tag fusion protein is applied to a column with immobilized Strep-Tactin (step 1). After the tagged protein has specifically bound to Strep-Tactin, a short washing step with a physiological buffer (e.g. phosphate buffered saline, PBS) removes all other host proteins (step 2). This is due to Strep-Tactin's low tendency to bind proteins non specifically. Then, the purified Strep-tag fusion protein is gently eluted with a low concentration of desthiobiotin, which specifically competes for the biotin binding pocket (step 3). To regenerate the column, desthiobiotin is removed by application of a HABA containing solution (a yellow azo dye).
Sources: en.wikipedia.org
Method validation is the documented process of showing that an HPLC procedure produces reliable results for a defined purpose. It examines parameters such as accuracy, precision, specificity, linearity, and robustness. Regulators and quality systems often require validation before routine use.
System suitability is a set of checks run on the chromatographic system before sample analysis. It confirms that resolution, peak shape, retention time, and response meet predefined limits. Failure can invalidate the run and trigger corrective action.
Blank injections reveal peaks or baseline disturbances that come from solvents, reagents, or the instrument rather than the sample. They help distinguish contamination from actual analyte signals. Comparing blanks with sample runs supports accurate interpretation.
It separates components in a liquid sample and measures their amounts using a detector. Results can indicate concentration, purity, or identity based on retention time and detector response. The technique works for mixtures that can be dissolved and filtered.